Pool Salt Cell Cleaning in Helotes, TX

Calcium scale forces your salt cell to work harder and produce less chlorine. We safely dissolve buildup to extend the life of your expensive saltwater generator.

Controlled Acid Bath

We use a properly diluted muriatic acid solution and a specialized cleaning stand to dissolve calcium scale without burning the delicate titanium plates inside the cell.

Scale Removal

Hard water causes rapid calcium buildup that blocks water flow. We carefully flush out all white crust and debris to restore full circulation through the generator.

Connection Inspection

We inspect the power cable connections and union threads for signs of corrosion or overheating, which are common failure points for aging saltwater systems.

Flow Switch Testing

We clean and verify the operation of the flow switch. A stuck or scaled flow switch will prevent the cell from generating chlorine, even if the cell itself is perfectly fine.

Chlorine Output Verification

After cleaning and reinstallation, we check the control panel to ensure the system recognizes the clean cell and is actively generating chlorine at the correct percentage.

Water Chemistry Review

We test your pool water to ensure the salinity, pH, and cyanuric acid levels are in the optimal range to support efficient chlorine generation.

Our technicians are highly experienced with all major saltwater chlorination systems. We routinely service Pentair IntelliChlor, Hayward AquaRite, and Jandy AquaPure cells. We understand the specific error codes, cleaning stands, and diagnostic procedures required for each brand.

The titanium plates coated in ruthenium inside your salt cell are highly sensitive. Using incorrect acid ratios or metal tools to scrape the plates will permanently ruin the cell. We use exact manufacturer-approved dilutions and procedures to safely dissolve scale while protecting your investment.

System Diagnostics

We start by checking your control panel for error codes, verifying the salt level in the water, and confirming that the cell actually requires cleaning rather than replacement.

Controlled Acid Bath

We disconnect the cell, secure it in a watertight stand, and pour in a mild, carefully measured acidic solution. We let it soak just long enough to dissolve the calcium scale without damaging the plates.

Reinstallation & Verification

We thoroughly rinse the cell with fresh water, inspect the O-rings, and reinstall it. Finally, we power the system back on and verify that the "Inspect Cell" light clears and chlorine production resumes.

Salt cells have a finite lifespan, typically lasting between three to seven years depending on usage, water chemistry, and maintenance. When a cell stops producing chlorine, the first step is always a thorough cleaning. If the titanium plates inside are still intact and coated, dissolving the calcium scale will fully restore the cell's function.

However, if the rare metal coating on the plates has completely depleted through years of use, cleaning will not bring the cell back to life. During our service, we inspect the plates closely. If we determine that the cell has reached the end of its lifespan, we will give you a clear, honest assessment and provide a free written quote for a replacement unit, with no pressure to decide immediately.

Why does my salt cell build up scale in Helotes?

How often should a salt cell be cleaned?

Does cleaning damage the salt cell?

Can I use regular muriatic acid to clean it myself?

Why is my chlorine still low after the cell was cleaned?

How long does a salt cell normally last?